Formation of levees, troughs and elevated channels by avalanches on erodible slopes

Snow avalanches are typically initiated on marginally stable slopes with a surface layer of fresh snow that may easily be incorporated into them. The erosion of snow at the front is fundamental to the dynamics and growth of snow avalanches and they may rapidly bulk-up, making them much more destructive than the initial release. Snow may also deposit at the rear, base and sides of the flow and the net balance of erosion and deposition determines whether an avalanche grows or decays. In this paper, small-scale analogue experiments are performed on a rough inclined plane with a static erodible layer of carborundum grains. The static layer is prepared by slowly closing down a flow from a hopper at the top of the slope. This leaves behind a uniform-depth layer of thickness hstop at a given slope inclination. Due to the hysteresis of the rough bed friction law, this layer can then be inclined to higher angles provided that the thickness does not exceed hstart, which is the maximum depth that can be held static on a rough bed. An avalanche is then initiated on top of the static layer by releasing a fixed volumeof carborundum grains. Dependent on the slope inclination and the depth of the static layer three different behaviours are observed. For initial deposit depths above hstop, the avalanche rapidly grows in size by progressively entraining more and more grains at the front and sides, and depositing relatively few particles at the base and tail. This leaves behind a trough eroded to a depth below the initial deposit surface and whose maximal areal extent has a triangular shape. Conversely, a release on a shallower slope, with a deposit of thickness hstop, leads to net deposition. This time the avalanche leaves behind a levee-flanked channel, the floor of which lies above the level of the initial deposit and narrows downstream. It is also possible to generate avalanches that have a perfect balance between net erosion and deposition. These avalanches propagate perfectly steadily downslope, leaving a constant-width trail with levees flanking a shallow trough cut slightly lower than the initial deposit surface. The cross-section of the trail therefore represents an exact redistribution of the mass reworked from the initial static layer. Granular flow problems involving erosion and deposition are notoriously difficult, because there is no accepted method of modeling the phase transition between static and moving particles. Remarkably, it is shown in this paper that by combining Pouliquen & Forterre’s (2002) extended friction law with the depth-averaged μ(I)-rheology of Gray & Edwards (2014) it is possible to develop a two-dimensional shallow water-like avalanche model that qualitatively captures all of the experimentally observed behaviour. Furthermore, the computed wavespeed, wave peak height and stationary layer thickness, as well as the distance traveled by decaying avalanches, are all in good quantitative agreement with the experiments. This model is therefore likely to have important practical implications for modeling the initiation, growth and decay of snow avalanches for hazard assessment and risk mitigation.